No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R010C00

This document describes IP multicast basics and how to configure IP multicast features, including IGMP/MLD, PIM (IPv4&IPv6), MSDP, multicast VPN, Layer 3 multicast CAC, Layer 2 multicast CAC, IGMP/MLD snooping, and multicast VLAN, IPv4&IPv6 multicast route management, static multicast MAC address, multicast network.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a Static Member Port

(Optional) Configuring a Static Member Port

Context

Group member ports are connected to user hosts, and can be learned dynamically or configured manually. After MLD snooping is enabled in a VLAN, all interfaces in the VLAN learn multicast protocols packets by default. When an interface receives an MLD Report message, it becomes a dynamic member port. A dynamic member port has an aging timer.

If the user hosts connected to an interface need to receive multicast packets of a specific group or sent from a specific source to a specific group, add the interface to the group or source-group manually. The interface then becomes a static member port. Static member ports will never age.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) Run:

    undo mld-snooping learning vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> | all }

    Dynamic learning of member ports is disabled.

    By default, dynamic learning of member ports is enabled. If this function is enabled, the interfaces that need to forward multicast data to hosts must be manually added to a multicast group.

  4. Run:

    mld-snooping static-group group-ipv6-address [ source source-ipv6-address ] vlan vlan-id

    The interface is manually added to a multicast group.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141903

Views: 155277

Downloads: 111

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next