No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R010C00

This document describes IP multicast basics and how to configure IP multicast features, including IGMP/MLD, PIM (IPv4&IPv6), MSDP, multicast VPN, Layer 3 multicast CAC, Layer 2 multicast CAC, IGMP/MLD snooping, and multicast VLAN, IPv4&IPv6 multicast route management, static multicast MAC address, multicast network.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Range of Multicast Groups That an Interface Can Join

(Optional) Configuring the Range of Multicast Groups That an Interface Can Join

Context

To limit the range of IPv6 multicast groups that an interface can join, configure ACL6 rules to filter received Multicast Listener Report messages so that the interface maintains group membership only in the allowed multicast groups.

Before specifying the range of multicast groups that an interface can join, configure an IPv6 access control list (ACL6) to define the range of multicast groups. For details about the ACL6 configuration, see ACL Configuration in the S7700 and S9700 V200R010C00 Configuration Guide - Security.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run:

    mld group-policy { acl6-number | acl6-name acl6-name } [ 1 | 2 ]

    The range of multicast groups that the interface can join is configured.

    By default, an interface can join any multicast group.

    NOTE:

    When configuring an ACL6 rule for an interface, use the permit parameter in the rule command to allow hosts connected to the interface to join groups within the specified range. If no rule is configured in the ACL6, hosts connected to the interface cannot join any multicast groups.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141903

Views: 145169

Downloads: 111

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next