No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R010C00

This document describes IP multicast basics and how to configure IP multicast features, including IGMP/MLD, PIM (IPv4&IPv6), MSDP, multicast VPN, Layer 3 multicast CAC, Layer 2 multicast CAC, IGMP/MLD snooping, and multicast VLAN, IPv4&IPv6 multicast route management, static multicast MAC address, multicast network.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Share-Group

Configuring a Share-Group

Context

An MD is a group of VPN instances that can transmit and receive multicast packets between PEs. Different VPN instances belong to different MDs. An MD serves a specific VPN. All private multicast data transmitted in the VPN is transmitted in the MD. Share-MDT is a basic concept of multicast VPN based on multicast domain (MD). A Share-MDT is a multicast distribution tree (MDT) established among all PE devices on a VPN. PE devices encapsulate VPN multicast packets into public network multicast data packets using the Share-Group address as the group address. These packets are then forwarded along the Share-MDT. The Share-MDT exists on the backbone network regardless of whether multicast services are running on the backbone network or VPNs.

Perform the following steps on a PE.

NOTE:

One Share-Group address cannot be configured for different VPN instances on a PE.

In MD VPN, the value range of a Share-Group address is the same as that of an Any-Source Multicast (ASM) group address range.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    ip vpn-instance vpn-instance-name

    The VPN instance view is displayed.

  3. (Optional) Run:

    ipv4-family

    The IPv4 address family is enabled for the VPN instance, and the VPN instance IPv4 address family view is displayed.

    By default, the VPN instance IPv4 address family is enabled after a router distinguisher (RD) and a VPN target are configured for a VPN instance.

  4. Run:

    multicast-domain share-group group-address binding mtunnel number

    A Share-Group is configured. The system automatically creates a multicast tunnel interface (MTI), binds the Share-Group to the MTI, and binds the MTI to the VPN instance.

    A VPN instance must be configured with the same Share-Group address on all PE devices. Each Share-Group address identifies a Share-MDT. If a VPN instance has different Share-Group addresses on PE devices, the Share-MDT cannot be established on the PE devices bound to the VPN instance.

    NOTE:

    After an MTI is created, the system automatically configures Protocol Independent Multicast (PIM) for the MTI. Manual configuration is not required. By default, PIM Sparse Mode (PIM-SM) is enabled for an MTI. If another interface is bound to the VPN instance, the PIM protocol enabled on the MTI automatically synchronizes with that configured on the interface.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141903

Views: 147604

Downloads: 111

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next