No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R010C00

This document describes IP multicast basics and how to configure IP multicast features, including IGMP/MLD, PIM (IPv4&IPv6), MSDP, multicast VPN, Layer 3 multicast CAC, Layer 2 multicast CAC, IGMP/MLD snooping, and multicast VLAN, IPv4&IPv6 multicast route management, static multicast MAC address, multicast network.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Filtering IGMP Messages Based on Source IP Addresses

Filtering IGMP Messages Based on Source IP Addresses

Context

A Layer 3 multicast switch directly connected to a user network segment processes all the IGMP messages received. To improve security and prevent multicast services from being affected by IGMP messages maliciously forged by other devices, you can configure IGMP message filtering on switch interfaces connected to hosts. The switch supports filtering of IGMP Query, Report and Leave messages.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run:

    igmp query ip-source-policy { basic-acl-number | acl-name acl-name }

    A policy is configured on the interface to filer Query messages based on source IP addresses.

    By default, the switch processes all the received Query messages without filtering them.

    NOTE:

    When configuring an access control list (ACL) for the interface, use the permit parameter to configure the interface to accept only Query messages with source addresses in a specified range. If no rule is configured in the ACL, the interface rejects all IGMP Query messages.

  5. Run:

    igmp ip-source-policy [ basic-acl-number | acl-name acl-name ]

    A policy is configured on the interface to filer Report/Leave messages based on source IP addresses.

    By default, the switch processes all the received Report/Leave messages without filtering them.

    After Report/Leave message filtering is configured without specifying an ACL, the switch processes Report/Leave messages based on source IP addresses as follows:

    • If the source IP address of a Report/Leave message is 0.0.0.0 or on the same network segment as the IP address of the inbound interface, the switch processes the Report/Leave message.

    • If the source IP address of a Report/Leave message is on a different network segment than the IP address of the inbound interface, the switch discards the Report/Leave message.

    NOTE:

    When configuring an ACL rule for the interface, use the permit parameter to configure the interface to accept only Report/Leave messages with source addresses in a specified range. If no rule is configured in the ACL, the interface rejects all IGMP Report/Leave messages.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141903

Views: 144530

Downloads: 111

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next