No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R010C00

This document describes IP multicast basics and how to configure IP multicast features, including IGMP/MLD, PIM (IPv4&IPv6), MSDP, multicast VPN, Layer 3 multicast CAC, Layer 2 multicast CAC, IGMP/MLD snooping, and multicast VLAN, IPv4&IPv6 multicast route management, static multicast MAC address, multicast network.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring MLD Snooping Proxy

Configuring MLD Snooping Proxy

Pre-configuration Tasks

Enabling MLD Snooping

Context

MLD snooping proxy enables the switch to send Query messages to user hosts in place of the upstream Layer 3 device, and to send MLD Report/Done messages to the Layer 3 device in place of user hosts. This function conserves bandwidth between the upstream device and switch.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    vlan vlan-id

    The VLAN view is displayed.

  3. Run:

    mld-snooping proxy

    MLD snooping proxy is enabled.

    NOTE:
    • If an IPv6 Layer 3 multicast function (such as MLD or IPv6 PIM) is enabled on the VLANIF interface, MLD snooping proxy cannot be enabled in the corresponding VLAN.

    • MLD querier and MLD message suppression can be enabled in the same VLAN to implement the MLD snooping proxy function. After you configure MLD snooping proxy in a VLAN, do not configure MLD snooping querier or MLD message suppression in the VLAN. For details about the configuration of MLD snooping querier and MLD message suppression, see (Optional) Configuring the MLD Snooping Querier and (Optional) Suppressing Report and Done Messages.

    • If multicast VLAN replication is configured on the switch, MLD snooping proxy cannot be enabled in user VLANs.

Checking the Configuration

After the configurations are complete, run the display mld-snooping [ vlan vlan-id ] configuration command in any view to check MLD snooping proxy configurations in the VLAN.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141903

Views: 153749

Downloads: 111

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next