No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Multicast

S7700 and S9700 V200R010C00

This document describes IP multicast basics and how to configure IP multicast features, including IGMP/MLD, PIM (IPv4&IPv6), MSDP, multicast VPN, Layer 3 multicast CAC, Layer 2 multicast CAC, IGMP/MLD snooping, and multicast VLAN, IPv4&IPv6 multicast route management, static multicast MAC address, multicast network.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Resetting the PIM Status of the Specified Downstream Interfaces in IPv6 PIM Entries

Resetting the PIM Status of the Specified Downstream Interfaces in IPv6 PIM Entries


You can reset the Join/Prune and Assert status on a specified downstream interface in an IPv6 PIM entry. MLD status and static groups on this interface are not affected.

Resetting the PIM status of downstream interfaces will trigger the sending of Join/Prune packets, which affects multicast services.


  • Run the reset pim ipv6 routing-table group ipv6-group-address mask ipv6-group-mask-length source ipv6-source-address interface interface-type interface-number command in the user view to reset the PIM status of specified downstream interfaces in specified IPv6 PIM entries.
Updated: 2019-08-21

Document ID: EDOC1000141903

Views: 153023

Downloads: 111

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next