No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R010C00

This document describes IP multicast basics and how to configure IP multicast features, including IGMP/MLD, PIM (IPv4&IPv6), MSDP, multicast VPN, Layer 3 multicast CAC, Layer 2 multicast CAC, IGMP/MLD snooping, and multicast VLAN, IPv4&IPv6 multicast route management, static multicast MAC address, multicast network.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an IPv6 Multicast Boundary

Configuring an IPv6 Multicast Boundary

Pre-configuration Tasks

Before configuring IPv6 multicast load splitting, complete the following tasks:

  • Configure an IPv6 unicast routing protocol to ensure normal unicast routing on the IPv6 network.
  • Run the multicast ipv6 routing-enable command in the system view to enable Layer 3 IPv6 multicast routing globally.

Context

To restrict forwarding of multicast packets sent to a multicast group within a range on an IPv6 multicast network, configure the IPv6 multicast boundary on interfaces. Then multicast packets sent to the group cannot be forwarded through the boundary interfaces.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

  4. Run:

    multicast ipv6 boundary { ipv6-group-address ipv6-group-mask-length | scope scope-id }

    An IPv6 multicast boundary is configured on the interface.

Checking the Configuration

After configuring an IPv6 multicast boundary on interfaces, check the IPv6 multicast routing table and information about the multicast boundary on the interfaces to verify that the IPv6 multicast network can operate normally.

  • Run the display multicast ipv6 routing-table [ ipv6-source-address [ ipv6-source-mask-length ] | ipv6-group-address [ ipv6-group-mask-length ] | incoming-interface { interface-type interface-number | register } | outgoing-interface { { exclude | include | match } { interface-type interface-number | register | none } } ] * [ outgoing-interface-number [ number ] ] command to check the IPv6 multicast routing table.
  • Run the display multicast ipv6 boundary [ ipv6-group-address ipv6-group-mask-length | scope scope-id ] [ interface interface-type interface-number ] command to check information about the IPv6 multicast boundary configured on an interface.
Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141903

Views: 155278

Downloads: 111

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next