No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R010C00

This document describes IP multicast basics and how to configure IP multicast features, including IGMP/MLD, PIM (IPv4&IPv6), MSDP, multicast VPN, Layer 3 multicast CAC, Layer 2 multicast CAC, IGMP/MLD snooping, and multicast VLAN, IPv4&IPv6 multicast route management, static multicast MAC address, multicast network.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Alarm Thresholds for Multicast Index Usage

Configuring Alarm Thresholds for Multicast Index Usage

Pre-Configuration Tasks

Before configuring alarm threshold for multicast index usage, configure basic multicast functions.

Context

Multicast packets are forwarded based on multicast forwarding entries in either Layer 2 or Layer 3 multicast mode. Multicast forwarding entries occupy independent indexes on the switch. A high index usage indicates more multicast forwarding entries and therefore higher load of the switch. If all indexes for multicast forwarding entries are used up, some multicast packets cannot be forwarded.

After alarm thresholds are set, the switch sends a trap when the index usage reaches the upper threshold or falls below the lower threshold. You can monitor multicast index usage based on the alarms.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    multicast threshold-alarm upper-limit upper-limit lower-limit lower-limit

    The alarm thresholds for multicast index usage are set.

    When the multicast index usage reaches upper-limit, an alarm is generated, indicating that the multicast forwarding entries will consume all indexes. When the multicast index usage falls below lower-limit, a clear alarm is generated, indicating that the multicast index usage is restored to the acceptable range.

    By default, the upper alarm threshold is 85%, and the lower alarm threshold is 75%.

Follow-up Procedure

  • Run the display multicast threshold-alarm command to view the alarm thresholds for multicast index resource usage.
Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141903

Views: 145725

Downloads: 111

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next