No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R010C00

This document describes IP multicast basics and how to configure IP multicast features, including IGMP/MLD, PIM (IPv4&IPv6), MSDP, multicast VPN, Layer 3 multicast CAC, Layer 2 multicast CAC, IGMP/MLD snooping, and multicast VLAN, IPv4&IPv6 multicast route management, static multicast MAC address, multicast network.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Multicast Deployment on an IPv6 Network

Multicast Deployment on an IPv6 Network

This section describes typical multicast service scenarios on an IPv6 network and applications of multicast protocols. Configure multicast services based on the actual situations and service requirements on your network. This section provides only deployment of basic multicast services.

Before deploying IPv6 multicast services on a network, ensure that IPv6 unicast routes on the network are reachable.

Figure 1-10  Basic IPv6 multicast service deployment

Table 1-13  Multicast protocols used for multicast on an IPv6 Network

Protocol

Application Position

Purpose

IPv6 PIM (mandatory)

IPv6 PIM must be configured on all interfaces of Layer 3 multicast devices, including all interfaces of RouterA, RouterB, and RouterC.

For the configuration procedure, see IPv6 PIM Configuration.

IPv6 PIM sends multicast data from the multicast source to RouterB and RouterC, which are connected to multicast receivers.

MLD (mandatory)

MLD must be configured on user-side interfaces of Layer 3 multicast devices RouterB and RouterC.

For the configuration procedure, see MLD Configuration.

MLD allows receiver hosts to join or leave multicast groups, and allows RouterB and RouterC to maintain and manage group memberships.

MLD snooping and MLD snooping proxy (optional)

MLD snooping and MLD snooping proxy must be configured on SwitchA, a Layer 2 device located between a Layer 3 multicast device and Host A.

For the configuration procedure, see MLD Snooping Configuration.

MLD snooping listens to MLD packets exchanged between RouterB and hosts to create and maintain a Layer 2 multicast forwarding table. In this manner, SwitchA can control forwarding of multicast data packets on the Layer 2 network.

With the MLD snooping proxy function, SwitchA can act in place of RouterB to send MLD Query messages to Host A, and in place of Host A to send MLD Report/Done messages to SwitchB.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141903

Views: 152078

Downloads: 111

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next