No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - IP Multicast

S7700 and S9700 V200R010C00

This document describes IP multicast basics and how to configure IP multicast features, including IGMP/MLD, PIM (IPv4&IPv6), MSDP, multicast VPN, Layer 3 multicast CAC, Layer 2 multicast CAC, IGMP/MLD snooping, and multicast VLAN, IPv4&IPv6 multicast route management, static multicast MAC address, multicast network.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clearing IGMP Snooping Entries

Clearing IGMP Snooping Entries


Static and dynamic IGMP snooping entries are cleared in different ways.

Static entries cannot be restored after being cleared. They will be created when you configure static member ports.

When dynamic entries in a forwarding table are cleared, hosts in the VLAN temporarily do not receive the multicast packets. These hosts can receive multicast packets again only after they send IGMP Report messages and the switch creates forwarding entries.


  • Run the undo l2-multicast static-group [ source-address source-ip-address ] group-address group-ip-address vlan { all | { vlan-id1 [ to vlan-id2 ] } &<1-10> } command in the interface view to remove the interface from a multicast group.

    You can run the following commands to batch remove multicast group addresses from an interface.

    • undo l2-multicast static-group [ source-address source-ip-address ] group-address group-ip-address1 to group-ip-address2 vlan vlan-id
    • undo l2-multicast static-group [ source-address source-ip-address ] group-address all vlan { all | { vlan-id1 [ to vlan-id2 ] } &<1-10> }

  • Run the reset igmp-snooping group { all | vlan { all | vlan-id [ [ source-address source-address ] group-address group-address ] } } command in the user view to remove dynamic entries in a forwarding table.
Updated: 2019-08-21

Document ID: EDOC1000141903

Views: 151949

Downloads: 111

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next