No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R010C00

This document describes IP multicast basics and how to configure IP multicast features, including IGMP/MLD, PIM (IPv4&IPv6), MSDP, multicast VPN, Layer 3 multicast CAC, Layer 2 multicast CAC, IGMP/MLD snooping, and multicast VLAN, IPv4&IPv6 multicast route management, static multicast MAC address, multicast network.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Group Address Range for a Channel

Configuring a Group Address Range for a Channel

Context

To control the number of multicast groups in a specified channel, configure a group address range for this channel.

After you configure a group address range for a channel, the device forwards multicast data to all groups by default, including the groups out of the configured range. If you want the device to forward only multicast data of the groups in the configured range, run the unspecified-channel deny command to filter out multicast data of groups out of the range.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    multicast-channel [ vpn-instance vpn-instance-name ]

    Layer 3 multicast CAC is enabled, and the multicast-channel view is displayed.

  3. Run:

    channel channel-name type { asm | ssm }

    A channel is created, and the channel view is displayed.

  4. Run:

    group group-address mask { group-mask-length | group-mask } [ source source-address mask { source-mask-length | source-mask } ] [ per-bandwidth traffic-rate ]

    A group address range and a source address range are configured for the channel.

  5. Run:

    quit

    Exit from the channel view.

  6. (Optional) Run:

    unspecified-channel deny

    The device is configured not to forward multicast data to the groups out of the group address range.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141903

Views: 155143

Downloads: 111

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next