No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Multicast

S7700 and S9700 V200R010C00

This document describes IP multicast basics and how to configure IP multicast features, including IGMP/MLD, PIM (IPv4&IPv6), MSDP, multicast VPN, Layer 3 multicast CAC, Layer 2 multicast CAC, IGMP/MLD snooping, and multicast VLAN, IPv4&IPv6 multicast route management, static multicast MAC address, multicast network.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Binding User VLANs to a Multicast VLAN

Binding User VLANs to a Multicast VLAN

Context

Multicast VLAN replication is implemented based on the multicast VLAN, which aggregates multicast flows from the network side. It allows the device to copy and deliver multicast packets in user VLANs. When you configure multicast VLAN replication based on user VLANs, you must enable Layer 2 multicast snooping in the multicast VLAN.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    igmp-snooping enable

    IGMP snooping is enabled globally.

  3. Run:

    vlan vlan-id

    A VLAN is created, and the VLAN view is displayed.

  4. Run:

    igmp-snooping enable

    IGMP snooping is enabled in the VLAN.

  5. (Optional) Run:

    igmp-snooping querier enable

    The IGMP snooping querier function is enabled in the VLAN.

    NOTE:
    This configuration is recommended in the multicast VLAN view. If the upstream device is the gateway with IGMP enabled, you do not need to perform step 5.

  6. Run:

    multicast-vlan enable

    Multicast VLAN is enabled and the current VLAN is configured as a multicast VLAN.

  7. Run:

    multicast-vlan user-vlan { vlan-id1 [ to vlan-id2 ] } &<1-10>

    The binding between a multicast VLAN and user VLANs is configured and user VLANs are bound to a multicast VLAN.

    NOTE:

    When you configure the binding between a multicast VLAN and user VLANs, a user VLAN can be bound to only one multicast VLAN.

  8. (Optional) Run:

    multicast-vlan send-query prune-source-port

    Query messages received in the multicast VLAN are prevented from being sent back to the upstream interface through user VLANs.

    By default, if an upstream interface belongs to a multicast VLAN and a user VLAN, Query messages sent to the multicast VLAN can be sent back from the upstream interface through the user VLAN. To prevent Query messages from being sent back to the upstream device, run this command in the multicast VLAN.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141903

Views: 144343

Downloads: 111

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next