Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
MPLS/5/L2VPN_ADD_VFP
Parameters
| Parameter Name | Parameter Meaning |
|---|---|
| SlotID | Indicates the numbers of the card and device where resources are exhausted. |
Possible Causes
1. VFP entry resources are exhausted.
2. The operation of adding the VFP entry is incorrect.
Procedure
- Run the display acl resource command to check whether VLAN ACL or VACL resources are exhausted.
- If so, go to step 2.
- If not, go to step 4.
- Run the display acl resource [ slot slot ] command to view information about ACL resources, including ACL4 and ACL6 resources.
- Run the display current-configuration command to check the current configuration on the switch.
- Check the services that occupy ACL resources based on ACL resource information and the current configuration as follows, and delete unnecessary services to release ACL resources.
- Check whether NAC, IPSG, MQC, and ACL-based simplified traffic policy services that occupy a large amount of ACL resources exist on the switch.
- Check the services that occupy ACL resources based on fields in the ACL resource information. For example, MQC, ACL-based simplified traffic policy, SVF, MPLS, and BFD for VPLS services occupy UDF ACL resources. If a large amount of UDF ACL resources are occupied, check these services first.
- Reconfigure a VSI and check whether the problem is rectified. If the problem is not rectified, go to step 6.
- Collect log information and configuration information, and then contact technical support personnel. You can collect diagnostic information using the display diagnostic-information command.