Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
DHCP/4/DHCP_INFO_LOG_DHCP_ADD_ACL_FAILED
Message
DHCP/4/DHCP_INFO_LOG_DHCP_ADD_ACL_FAILED:Add ACL failed because of no enough ACL resources.(Slot = [slot-id])
Possible Causes
If the ACL resources are insufficient, the configured DHCP commands do not take effect.
Procedure
- Adjust the usage of ACL resources using either of the following methods:
Run the display acl resource command to view information about ACL resources and check services that occupy many ACL resources.
Run the display current-configuration command to view configuration information. Delete unused configurations to release ACl resources.
- Delete DHCP-related commands and reconfigure commands related to the DHCP service to redeliver the DHCP service. After performing the preceding operations, check whether the log is still generated.
- If the log is not generated, go to step 4.
- If the log is still generated, go to step 3.
- Collect log information and configuration information, and then contact technical support personnel. You can collect diagnostic information using the display diagnostic-information command.
- End.
