Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ACLE/3/POLICY_APPLY
Parameters
| Parameter Name | Parameter Meaning |
|---|---|
| [STRING] | Indicates the view to which a traffic policy is applied. |
| ErrorInformation | Indicates the error reason. |
Procedure
- Run the display traffic-policy applied-record command to check whether the traffic policy is applied successfully.
- If so, no further action is required.
- If not, go to step 2.
- Check whether MQC has a configuration conflict according
to error information in the logs.
- If so, go to step 3.
- If not, go to step 4.
- Remove the conflicting configuration and reconfigure a
traffic policy. Run the display traffic-policy applied-record command to check whether the new traffic policy is applied successfully.
- If so, no further action is required.
- If not, go to step 7.
- Check whether MQC has insufficient resources according
to error information in the logs.
- If so, go to step 5.
- If not, go to step 7.
- Run the display traffic-policy applied-record command to check whether redundant traffic policies are configured.
- If so, go to step 6.
- If not, go to step 7.
- Delete redundant traffic policies and reconfigure a traffic
policy. Run the display traffic-policy applied-record command to check whether the new traffic policy is applied successfully.
- If so, no further action is required.
- If not, go to step 7.
- Collect log information and configuration information, and then contact technical support personnel. You can collect diagnostic information using the display diagnostic-information command.
