Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ACLE/3/IPC_FAIL
Parameters
| Parameter Name | Parameter Meaning |
|---|---|
| [ULONG] | Indicates the slot ID of the LPU. |
| MessageName | Indicates the name of message
where an IPC error occurs, for example:
|
Procedure
- Run the display device command to check
whether the LPU has registered.
- If so, go to step 3.
- If not, go to step 2.
- If the LPU has not registered, IPC communication fails, which is normal. This log is informational only, and no action is required.
- Collect log information about IPC message sending failures of the LPU, and contact technical support personnel. You can collect diagnostic information using the display diagnostic-information command.
