Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
L3AD/4/RESOURCE_FULL
Description
The entry resources of a chip are allocated, and the current resources are insufficient.
Parameters
| Parameter Name | Parameter Meaning |
|---|---|
| Type | entry type of a chip, including:
|
Possible Causes
The usage of entry resources is beyond the range. It is recommended to release part of resources.
Procedure
- Perform the following operations based on the chip entry
type in the alarm:
If the number of Layer 3 egress entry resources is not enough, delete redundant VLANIF and tunnel interfaces.
If the number of next-hop entry resources is not enough, shut down certain egresses.
If the number of next-hop group entry resources is not enough, delete certain equivalent routes. In case of static routes, you can delete some unnecessary routes. In case of dynamic routes, you can run the maximum load-balancing command to reduce the maximum number of equal-cost routes.
- If the fault persists, collect log information and configuration information, and then collect log information and configuration information, and then contact technical support personnel. For details, see Troubleshooting-Information Collection-Collecting Diagnostic Information.
