Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
SW_SNPG/4/RPC_FAIL
Message
SW_SNPG/4/RPC_FAIL:Failed to send the configuration to LPU because of the failure of RPC. (Slot=[STRING])
Procedure
- Run the display device command to check
whether the LPU has registered.
- If so, go to step 3.
- If not, go to step 2.
- If the LPU has not registered, RPC communication fails, which is normal. This log is informational only, and no action is required.
- Collect log information about RPC message sending failures of the LPU, and contact technical support personnel. You can collect diagnostic information using the display diagnostic-information command.