No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
Configuration Guide - Interface Management
S1720, S2700, S5700, and S6720 V200R010C00

This document describes the principles and configurations of interfaces and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring MEth Management Interface Attributes

Configuring MEth Management Interface Attributes

Context

The MEth0/0/1 management interface is a special Ethernet interface that allows users to log in to the device to perform configuration and management operations. It can be assigned an IP address. The MEth management interface does not transmit services.

For details on how to log in to the device through the management interface, see S1720, S2700, S5700, and S6720 V200R010C00 Configuration Guide - Basic Configuration.

Procedure

  1. Run:
    system-view

    The system view is displayed.

  2. Run:
    interface meth 0/0/1

    The MEth management interface view is displayed.

  3. Run:
    undo negotiation auto

    The MEth management interface is configured to work in non-auto-negotiation mode.

    By default, the MEth management interface works in auto-negotiation mode.

    NOTE:

    When the management interface works in auto-negotiation mode, the rate and duplex mode cannot be configured on the interface.

    Interfaces at both ends of a link must use the same auto-negotiation mode. The interfaces cannot communicate with each other if they use different auto-negotiation modes.

  4. Run:

    speed { 10 | 100 | 1000 }

    The rate is configured for the MEth management interface.

    By default, the MEth management interface works at the maximum rate of 100 Mbit/s.

  5. Run:

    duplex { full | half }

    The duplex mode is configured for the MEth management interface.

    By default, the MEth management interface works in full-duplex mode.

Translation
Download
Updated: 2019-12-28

Document ID: EDOC1000141936

Views: 54834

Downloads: 786

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next