No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Interface Management

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the principles and configurations of interfaces and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Configure Multiple Physical Interfaces in a Batch?

How Do I Configure Multiple Physical Interfaces in a Batch?

You can add multiple Ethernet interfaces to the same port group. After you run a configuration command once in the port group view, the configuration takes effect on all the Ethernet interfaces in the port group, reducing the configuration workload.

# Add GE0/0/1 to GE0/0/20 to port group portgroup1.
<HUAWEI> system-view
[HUAWEI] port-group portgroup1
[HUAWEI-port-group-portgroup1] group-member gigabitethernet 0/0/1 to gigabitethernet 0/0/20
Updated: 2019-12-28

Document ID: EDOC1000141936

Views: 50075

Downloads: 783

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next