No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Reliability

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Interval for Sending Traps

Setting the Interval for Sending Traps


If the BFD module is enabled with the SNMP alarm function, the NMS will receive BFD Up or Down messages. If the BFD session flaps, the NMS receives a large number of traps. In this case, BFD traps need to be suppressed. Run the snmp-agent bfd trap-interval command to set the interval at which traps are sent to prevent overflow of traps.


  1. Run:


    The system view is displayed.

  2. Run:


    BFD is enabled globally and the BFD view is displayed.

  3. Run:

    snmp-agent bfd trap-interval interval

    The interval at which traps are sent is set.

    By default, the interval at which traps are sent is 120s.

Updated: 2019-08-21

Document ID: EDOC1000141941

Views: 90370

Downloads: 512

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next