No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Reliability

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Device Priority in a VRRP6 Group

Setting the Device Priority in a VRRP6 Group


Devices with higher priorities in a VRRP6 group are more likely to become the master. You can specify the master to forward traffic by setting device priorities.


  1. Run:


    The system view is displayed.

  2. Run:

    interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

    Only the S5720HI, S5720EI, S6720EI, and S6720S-EI support switching between Layer 2 and Layer 3 modes.

  4. Run:

    vrrp6 vrid virtual-router-id priority priority-value

    The device priority in a VRRP6 group is set.

    By default, the device priority is 100.

    • Priority 0 is reserved in the system. Priority 255 is reserved for the IP address owner. The configurable priority ranges from 1 to 254.

    • The priority of an IP address owner is fixed at 255 and cannot be manually changed. You can run the vrrp vrid virtual-router-id priority priority-value command to change the priority of an IP address owner, but the configured priority does not take effect. If a VRRP device is no longer an IP address owner, the configured priority is used.

    • When devices in a VRRP6 group have the same priority and attempt to be the master simultaneously, the device where the interface with the largest IP address resides becomes the master. The device that first enters the Master state becomes the master, and other backups remain unchanged.

Updated: 2019-08-21

Document ID: EDOC1000141941

Views: 91521

Downloads: 512

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next