No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Reliability

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Are VRRP Heartbeat Packets Sent in a Super-VLAN?

How Are VRRP Heartbeat Packets Sent in a Super-VLAN?

You can use the vrrp advertise send-mode command to configure the mode in which VRRP heartbeat packets are sent in a super-VLAN. To reduce the number of VRRP heartbeat packets on the Layer 2 network, configure the device to send VRRP heartbeat packets in all sub-VLANs or a specified sub-VLAN.

Updated: 2019-08-21

Document ID: EDOC1000141941

Views: 91843

Downloads: 513

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next