No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Introduction to Y.1731

Introduction to Y.1731

Y.1731 is used to implement end-to-end connectivity detection, loopback detection, and link trace on Metro Ethernets (MEs). It also provides test diagnosis and performance monitoring functions such as frame loss measurement, frame delay measurement, frame jitter measurement, and throughput measurement.

Ethernet in the First Mile (EFM) and Connectivity Fault Management (CFM) are used to detect link faults for carriers. Y.1731, an enhancement of CFM, can be configured to monitor service performance.

Hierarchical Ethernet operation, administration and maintenance (OAM) needs to be provided based on the network architecture, as shown in Figure 10-1.

Figure 10-1  Ethernet OAM networking

Y.1731 is an OAM protocol defined by the Telecommunication Standardization Sector of the International Telecommunication Union (ITU-T). It covers items defined in IEEE 802.1ag and provides additional OAM messages for fault management and performance monitoring. Fault management includes alarm indication signal (AIS), remote defect indication (RDI), locked signal (LCK), test signal, automatic protection switching (APS), maintenance communication channel (MCC), experimental (EXP) OAM, and vendor specific (VSP) OAM. Performance monitoring includes frame loss measurement (LM) and delay measurement (DM).

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141941

Views: 90764

Downloads: 512

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next