No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Using VRRP to Implement Load Balancing

Using VRRP to Implement Load Balancing

VRRP active/standby is configured on a gateway to implement gateway redundancy. To reduce the burden of data traffic on the active device, VRRP load balancing can be used to load balance uplink traffic.

Multi-Gateway Load Balancing

Multiple VRRP groups with virtual IP addresses are created, and different VRRP groups are specified as gateways for different users, to implement load balancing.

Figure 4-11  Multi-gateway load balancing
As shown in Figure 4-11, two VRRP groups are configured:
  • VRRP group 1: SwitchA functions as the master and SwitchB as the backup.
  • VRRP group 2: SwitchB functions as the master and SwitchA as the backup.

VRRP groups 1 and 2 are gateways for different user hosts. The VRRP groups load balance traffic and back up each other.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141941

Views: 70256

Downloads: 481

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next