No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Reliability

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the configuration of BFD, DLDP, VRRP, SmartLink, CFM, EFM, Y.1731 and MAC swap loopback to ensure reliability on the device.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating an RMEP

Creating an RMEP


For other devices in the same MA, their MEPs are RMEPs for the local device. By configuring an RMEP, you can perform connectivity fault detection between the local MEP and the RMEP in one MA. If you need to detect the connectivity between a device and an RMEP, you need to create the RMEP first.


  1. Run:


    The system view is displayed.

  2. Run:

    cfm md md-name

    The MD view is displayed.

  3. Run:

    ma ma-name

    The MA view is displayed.

  4. Run:

    remote-mep mep-id mep-id [ mac mac-address ]

    An RMEP in the current MA is created.

Follow-up Procedure

  • If you need to create multiple RMEPs in an MA, repeat Step 4.

  • If you need to create multiple RMEPs in multiple MAs, repeat Step 3 and Step 4.

  • If you need to create multiple RMEPs in multiple MDs, repeat Step 2 to Step 4.

Updated: 2019-08-21

Document ID: EDOC1000141941

Views: 90761

Downloads: 512

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next