No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a PW

Configuring a PW

Context

Only LDP PWs can be configured.

Do as follows on the SPE and the UPE devices:

Procedure

  • Configure a PW in HVPLS networking mode.

    For details, see Configuring LDP HVPLS.

    1. Run:

      system-view

      The system view is displayed.

    2. Run:

      vsi vsi-name static

      A VSI is created and the static member discovery mode is specified.

    3. Run:

      pwsignal ldp

      LDP is configured as the PW signaling protocol and the VSI-LDP view is displayed.

    4. Run:

      vsi-id vsi-id

      The VSI ID is set.

    5. Run the following commands to configure VSI peers and establish PWs:

      • To specify an SPE as the peer of the UPE or to specify an NPE as the peer of an SPE, run:

        peer peer-address [ negotiation-vc-id vc-id ] [ tnl-policy policy-name ]
      • To specify the UPE as the peer of an SPE, run:

        peer peer-address [ negotiation-vc-id vc-id ] [ tnl-policy policy-name ] upe  [ ignore-standby-state ]

      From the perspective of the UPE, the PW between itself and an SPE is a hub PW; from the perspective of an SPE, the PW between itself and the UPE is a spoke PW.

    6. Run:

      quit

      Return to the VSI view.

    7. Run:

      quit

      Return to the system view.

    8. Run:

      interface interface-type interface-number

      The AC interface view is displayed.

      This command must be run on the UPEs, but does not need to be run on the SPEs. In this scenario, the AC interface of the UPE is an Ethernet interface.

    9. Run:

      undo portswitch

      The Layer 2 interface is configured as a Layer 3 interface.

    10. Run:

      l2 binding vsi vsi-name

      The AC interface is bound to the VSI.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141944

Views: 110730

Downloads: 588

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next