No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting Attributes for a PW Template

Setting Attributes for a PW Template


In load balancing, packet mis-sequencing may occur. The device can reassemble the packets using the control word function. To detect a PW based on a control word channel, you must enable the control word function by using a PW template before configuring dynamic BFD for PWs. Perform the following operations on the two PEs of the PW.


  1. Run:


    The system view is displayed.

  2. Run:

    pw-template pw-template-name

    The PW template view is displayed.

  3. Run:


    The control word function is enabled.

Updated: 2019-08-21

Document ID: EDOC1000141944

Views: 111816

Downloads: 588

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next