No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Checking the Configuration

Checking the Configuration

Prerequisites

All configurations of static VLLs to access a VPLS network are complete.

Procedure

  • Run the display mpls static-l2vc [ interface interface-type interface-number ] command to check information about the static VC configured on the switch.
  • Run the display l2vpn ccc-interface vc-type static-vc up command to check information about VC interfaces in SVC mode in Up state.
  • Run the display vsi [ name vsi-name ] [ verbose ] command to check information about a VPLS VSI.
  • Run the display vsi remote ldp [ router-id ip-address ] [ pw-id pw-id ] command to check information about a remote VSI.
  • Run the display vpls connection [ ldp | vsi vsi-name ] [ down | up ] [ verbose ] command to check information about a VPLS connection.
  • Run the display mac-address dynamic slot-id command to check dynamic MAC address entries.
Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141944

Views: 111636

Downloads: 588

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next