No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring VPNv4 FRR

Configuring VPNv4 FRR

Context

In an HVPN scenario in which VPNv4 FRR is configured, if the active LSP between an SPE and its next hop is unreachable, traffic can be rapidly switched to the standby LSP for transmission.

VPNv4 FRR is applicable to HVPN networks.
  • Figure 3-45 shows an HVPN network. On the network, VPNv4 FRR is configured on the SPE. If the LSP (Link A) from the SPE to PE1 fails, traffic is automatically switched to the LSP (Link B) from the SPE to PE2, to minimize the impact of the link failure on VPN services.

Figure 3-45  VPNv4 FRR used on an HVPN network

VPNv4 FRR is deployed in different locations on HVPN networks:

  • On an HVPN network, VPNv4 FRR is deployed on SPE nodes.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  3. Run:

    ipv4-family vpnv4

    The BGP-VPNv4 address family view is displayed.

  4. Run:

    auto-frr

    VPNv4 FRR is enabled.

  5. Run:

    bestroute nexthop-resolved tunnel

    The system is configured to select a VPNv4 route only when the next hop is iterated to a tunnel. This configuration prevents packet loss during a revertive switchover.

Checking the Configuration

Run the display mpls lsp include ip-address mask-length verbose command to check the index and label of the backup LSP to which the VPNv4 route is iterated.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141944

Views: 111387

Downloads: 588

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next