No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Static LSP Between the UPE and the SPE

Configuring the Static LSP Between the UPE and the SPE

Context

Before configuring a static VLL, you need to configure a static LSP.

Do as follows on the SPE and the UPE devices:

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    static-lsp ingress lsp-name destination ip-address { mask-length  | mask } { nexthop next-hop-address | outgoing-interface interface-type interface-number } * out-label out-label
    or
    static-lsp ingress tunnel-interface interface-type interface-number destination ip-address { nexthop next-hop-address | outgoing-interface interface-type interface-number } * out-label out-label

    The ingress node is configured for the LSP.

    The next hop must be configured instead of the outgoing interface for non-P2P link.

  3. Run:

    static-lsp egress lsp-name [ incoming-interface interface-type interface-number ] in-label in-label [ lsrid ingress-lsr-id tunnel-id tunnel-id ]

    The egress of the LSP is configured.

    NOTE:
    • Between the UPE and the SPE, two static LSPs with opposite directions must be configured because the static LSP is unidirectional.

    • If P devices exist between the UPE and the SPE, the static-lsp transit command must be configured on the P devices to configure the transit of the static LSP.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141944

Views: 111873

Downloads: 588

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next