No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - VPN

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
VPN Dual-Stack Access

VPN Dual-Stack Access

Carriers face a shortage of IPv4 addresses and many carriers have started to deploy IPv6 networks to address this shortage. For widely deployed BGP/MPLS IPv4 VPN services, VPN dual-stack access is a good choice for the transition from IPv4 to IPv6.

VPN interfaces originally only supported a single type of protocol stack. VPN dual-stack allows a VPN to use both IPv4 and IPv6 address families. This allows interfaces bound to a VPN to support both IPv4 VPN and IPv6 VPN.

Figure 3-34 shows a network diagram of VPN dual-stack access.

Figure 3-34  Networking diagram of VPN dual-stack access

In Figure 3-34, IPv4/IPv6 VPN dual-stack access allows VPN sites to support both IPv4 and IPv6 networks. IPv4 and IPv6 services are also transmitted to a PE device through the same interface.

Updated: 2019-08-21

Document ID: EDOC1000141944

Views: 110766

Downloads: 588

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next