No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Route Reflection for the Routes of the BGP VPN Instance

Configuring Route Reflection for the Routes of the BGP VPN Instance

Context

Perform the following steps on the RR.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  3. Run:

    ipv6-family vpnv6

    The BGP IPv6 VPN address family view is displayed.

  4. Enable the route reflection for BGP IPv6 VPN routes on the RR.

    • Run the peer { group-name | ipv4-address } reflect-client command to enable the route reflection if the RR establishes the MP IBGP connection with the peer group consisting of all Client PEs.

    • Run the peer ipv4-address reflect-client command repeatedly to enable the route reflection if the RR establishes the MP IBGP connection with each PE rather than peer group.

  5. Run:

    undo policy vpn-target

    The filtering of IPv6 VPN routes based on the VPN target is disabled.

  6. (Optional) Run:

    rr-filter { extcomm-filter-number | extcomm-filter-name }

    The reflection policy is configured for the RR.

    To allow an RR to filter routes to be reflected, run the rr-filter command. Only IBGP routes of which the RT extended community attribute matches the reflection policy can be reflected.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141944

Views: 112142

Downloads: 588

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next