No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IP FRR for VPN Routes

Configuring IP FRR for VPN Routes

Pre-configuration Tasks

Before configuring IP FRR for VPN routes, complete the following tasks:

  • Configure basic BGP/MPLS IP VPN functions (OSPF between the PE and CE). For details, see Configuring Basic BGP/MPLS IP VPN Functions.
  • Ensure that the PE has learned VPN routes with the same prefix from the attached CE devices.

Context

IP FRR for VPN routes is used in scenarios where multiple CE devices connect to one PE device. As shown in Figure 3-42, the PE device forwards data to the site of vpn1 through Link_A, and Link_B is a backup link. When the PE device detects that the route to CE1 is unreachable, it immediately switches traffic to Link_B and then performs other operations to trigger VPN route convergence. This minimizes impact of the link failure on VPN services.

Figure 3-42  IP FRR for VPN routes

Perform the following configuration on a PE device that connects to multiple CE devices.

Procedure

  • configuring IP FRR
    1. Run:

      system-view

      The system view is displayed.

    2. Run:

      route-policy route-policy-name { permit | deny } node node

      A node is configured for a route-policy, and the route-policy view is displayed.

    3. Run:

      apply backup-interface interface-type interface-number

      A backup outbound interface is specified.

    4. (Optional) Run:

      apply backup-nexthop ip-address

      A backup next hop is specified.

    5. Run:

      quit

      Return to the system view.

    6. Run:

      ip vpn-instance vpn-instance-name

      The VPN instance view is displayed.

    7. Run:

      ipv4-family

      The VPN instance IPv4 address family view is displayed.

    8. Run:

      ip frr route-policy route-policy-name

      IP FRR is enabled for the VPN instance IPv4 address family.

Checking the Configuration

Run the display ip routing-table vpn-instance vpn-instance-name [ ipv4-address ] verbose command to check the backup next hops and backup outbound interfaces of VPN-IPv4 routes in the routing table.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141944

Views: 110388

Downloads: 588

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next