No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Overview

Overview

IPv6 is an enhanced version of IPv4 and an Internet protocol of the next generation. IPv6 provides the improved address space, configuration, maintenance, and security functions, and supports more access users and devices that access the Internet than IPv4. Some campuses and companies start using IPv6 addresses internally to address the problem of IPv4 address shortage. Currently, communication on IPv6 networks depends on the backbone IPv4 networks. The BGP/MPLS IPv6 VPN technology is used to establish internal IPv6 networks.

The BGP/MPLS IPv6 VPN is a Layer 3 virtual private network (L3VPN). BGP/MPLS IPv6 VPN uses the Border Gateway Protocol (BGP) to advertise VPN routes and the Multiprotocol Label Switching (MPLS) to forward VPN packets on backbone networks, which are IP networks, of service providers (SPs). "IPv6" here refers to the IPv6 packets transmitted by VPNs.

On an IPv6 VPN, a provider edge (PE) receives IPv6 packets from customer edges (CEs); however, on an IPv4 VPN, a PE receives IPv4 packets from CEs.

Currently, IPv6 VPN services are implemented through IPv4 backbone networks of SPs. In this case, the PE must support IPv4/IPv6 dual stack because the backbone network is an IPv4 network and the client sites use IPv6 address family, as shown in Figure 4-1. Any network protocols that can carry IPv6 traffic can be used between CEs and PEs. User-side interfaces on the PEs run IPv6, and network-side interfaces run IPv4.

Figure 4-1 shows the basic model of a BGP/MPLS IPv6 VPN.

Figure 4-1  Model of a BGP/MPLS IPv6 VPN

IPv6 VPN uses Multiprotocol Extensions for BGP-4 (MP-BGP) to advertise VPNv6 routes on the backbone network, triggers MPLS to allocate labels for IPv6 packet identification, and uses tunnels such as LSPs and MPLS Traffic Engineering (MPLS TE) tunnels to transmit VPN data on the backbone network. The implementation principle of an IPv6 VPN is similar to that of a BGP/MPLS IP VPN.

Currently, the device supports the following IPv6 VPN networking schemes:

  • Intranet VPN

  • Extranet VPN

  • Hub and Spoke

  • Inter-AS VPN

For description about these networking schemes, see BGP/MPLS IP VPN Configuration in this manual.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141944

Views: 70456

Downloads: 501

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next