No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring L2VPN Instances on PE Devices

Configuring L2VPN Instances on PE Devices

Context

On a Kompella VLL network, L2VPN instances are configured on PE devices, with each L2VPN instance representing a private Kompella VLL network. In an L2VPN instance, the PE device creates one CE entity for each CE device connected to it and assigns a CE ID to each CE entity. The CE ID is unique within the L2VPN instance. Any two CE devices in this L2VPN instance can set up P2P VLL connections to communicate at Layer 2.

Procedure

  • Perform the following operations on the PE devices at both ends of a VC:
    1. Run:

      system-view

      The system view is displayed.

    2. Run:

      mpls l2vpn l2vpn-name encapsulation { ethernet | vlan } [ control-word | no-control-word ]

      An L2VPN instance is created, an encapsulation mode is specified for the L2VPN instance, and the MPLS L2VPN instance view is displayed.

    3. Run:

      route-distinguisher route-distinguisher

      An RD is configured for the L2VPN instance.

      An L2VPN instance takes effect only after the RD is configured. Each L2VPN instance on a PE must have a unique RD.

      The RD cannot be changed once it is configured. The only way to modify the RD is to delete this VLL and create a new one.

    4. (Optional) Run:

      mtu mtu-value

      The Layer 2 MTU is set for the VPN.

      The MTU for the VPN must be consistent throughout the entire network. If different MTU values are configured for the same VPN on two PEs, the two PEs cannot exchange reachability information or set up connections. By default, the MTU of an MPLS-L2VPN instance is 1500 bytes.

      Devices of some manufacturers do not support the MTU matching check in the L2VPN instance. When Huawei devices are used with non-Huawei devices in Kompella mode, either:

      • Configure the L2VPN MTU on the PE to be the same as that on the non-Huawei devices.

      • Use the ignore-mtu-match command to disable the MTU matching check.

    5. Run:

      vpn-target vpn-target & <1-16> [ both | export-extcommunity | import-extcommunity ]

      The VPN target is configured for the L2VPN instance. A VPN target is a BGP extended community attribute. It is used to control the receiving and advertisement of L2VPN information. A maximum of 16 VPN targets can be configured using a vpn-target command.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141944

Views: 109679

Downloads: 586

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next