No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - VPN

S1720, S2700, S5700, and S6720 V200R010C00

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Inter-AS VPN Option A

Configuring Inter-AS VPN Option A

Procedure

To implement inter-AS VPN Option A, complete basic BGP/MPLS IP VPN configuration in each AS and configure the ASBR-PE devices as the CE device of each other. You need to configure VPN instances for a PE device and an ASBR-PE device respectively. The PE device connects to CE devices, and the ASBR-PE device connects to the remote ASBR-PE device. For details about basic BGP/MPLS IP VPN configuration, see Configuring Basic BGP/MPLS IP VPN Functions.

NOTE:
In inter-AS VPN Option A, the VPN targets of VPN instances on the ASBR and PE devices in the same AS must match for the same VPN. This is not required for the PE devices in different ASs.

Checking the Configuration

After inter-AS VPN Option A is configured, run the following commands to check previous configurations.

  • Run the display bgp vpnv4 all peer command on the PE or ASBR, and you can view that the status of the BGP VPNv4 peer relationship between the PE and ASBR in the same AS is "Established".

  • Run the display bgp vpnv4 all routing-table command on the PE or ASBR, and you can view the VPNv4 routes.

  • Run the display ip routing-table vpn-instance vpn-instance-name command on the PE or ASBR, and you can view that the VPN routing table of the PE or ASBR has related VPN routes.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000141944

Views: 102466

Downloads: 572

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next