No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S5720HI V200R010C00 Configuration Guide - WLAN-AC

This document describes native AC (hereinafter referred to as WLAN AC) configuration procedures and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Rogue Device Detection and Containment

Rogue Device Detection and Containment

In Figure 10-5, an employee connects to a rogue fat AP from the campus network or uses simulation software to simulate a fat AP and deceive users into connecting to the corresponding SSID. After WIDS and WIPS are configured, the AC identifies the rogue AP. The monitor AP then uses the rogue AP's identity information to broadcast a Deauthentication frame. After STAs associating with the rogue AP receive the Deauthentication frame, they disassociate from the rogue AP. This countermeasure prevents STAs from associating with the rogue AP.

Figure 10-5  Configuring WIDS and WIPS against rogue devices

Updated: 2019-12-28

Document ID: EDOC1000141952

Views: 201215

Downloads: 522

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next