No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S5720HI V200R010C00 Configuration Guide - WLAN-AC

This document describes native AC (hereinafter referred to as WLAN AC) configuration procedures and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating an AP Group

Creating an AP Group


On an AC + Fit AP network, one AC manages many APs. Usually, you need to perform the same configurations on the APs. In this situation, you can add the APs to an AP group and perform configurations uniformly in the AP group, which simplifies operations. All APs in the group use the same configurations.

Each AP must and can only join one AP group. An AP group contains configurations shared by all APs. You can configure configurations specific to a single AP in the AP view.

By default, an AP automatically joins the AP group default. The AP group default cannot be deleted, but you can modify configurations in the default AP group.

By default, an AP group has the following profiles bound: AP system profile default, 2G radio profile default, 5G radio profile default, regulatory domain profile default, WIDS profile default, and AP wired port profile default.

Pre-configuration Tasks

Before creating an AP group, perform the task of CLI Login Configuration.


  1. Run:


    The system view is displayed.

  2. Run:


    The WLAN view is displayed.

  3. Run:

    ap-group name group-name

    An AP group is created, and the AP group view is displayed.

    By default, the system provides the AP group default.

Verifying the Configuration

  • Run the display ap-group { all | name group-name } command to verify AP group configurations.

Follow-up Procedure

After an AP group is created, you need to add APs to the AP group so that the APs can use configurations in the group. For details, see Adding APs.

Updated: 2019-12-28

Document ID: EDOC1000141952

Views: 201223

Downloads: 522

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next