No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S5720HI V200R010C00 Configuration Guide - WLAN-AC

This document describes native AC (hereinafter referred to as WLAN AC) configuration procedures and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a STA Whitelist Profile

Configuring a STA Whitelist Profile


A STA whitelist profile contains MAC addresses of STAs allowed to connect to the WLAN. To allow only some STAs to connect to the WLAN, configure a STA whitelist profile and apply the STA whitelist profile to an AP system profile or a VAP profile.

The effective scope of the STA whitelist profile differs according to the profiles to which it is applied.
  • AP system profile: The STA whitelist profile takes effect based on the AP. APs using the AP system profile will use the STA whitelist. The STA whitelist profile takes effect on all STAs connected to the APs (all VAPs).
  • VAP profile: The STA whitelist profile takes effect based on the VAP. If the STA whitelist profile is applied to an AP, the STA whitelist profile applies only to STAs connected to the corresponding VAPs.

If the STA blacklist or whitelist profiles are configured in both an AP system profile and a VAP profile, a STA can connect to the WLAN only when it is permitted by both the configuration in the AP system profile and VAP profile.

If a STA whitelist profile is empty, no STA can connect to the WLAN to access network resources.


  1. Run:


    The system view is displayed.

  2. Run:


    The WLAN view is displayed.

  3. Run:

    sta-whitelist-profile name profile-name

    A STA whitelist profile is created and the STA whitelist profile view is displayed.

    By default, no STA whitelist profile is created.

  4. Run:

    sta-mac mac-address

    The MAC address of a STA is added.

    You can configure a maximum of 3276 STA MAC addresses in a STA whitelist profile.

    By default, the MAC address of a STA is not added to the whitelist.

Updated: 2019-12-28

Document ID: EDOC1000141952

Views: 204072

Downloads: 522

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next