No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S5720HI V200R010C00 Configuration Guide - WLAN-AC

This document describes native AC (hereinafter referred to as WLAN AC) configuration procedures and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Smart Antenna Function

Configuring the Smart Antenna Function

Pre-configuration Tasks

Before configuring the smart antenna function, perform the task of WLAN Service Configuration.


After the smart antenna function is enabled, an AP can select a proper antenna array based on STAs' locations, improving signal strength and user experience.

  • The AP7030DE, and AP7050DE support the smart antenna function.
  • The smart antenna function cannot take effect if beamforming or MU-MIMO has been configured.


  1. Run:


    The system view is displayed.

  2. Run:


    The WLAN view is displayed.

  3. Run:

    radio-2g-profile name profile-name or radio-5g-profile name profile-name

    The 2G or 5G radio profile view is displayed.

  4. Run:

    smart-antenna enable

    The smart antenna function is enabled for APs.

    By default, the smart antenna function is disabled for APs.

  5. Run:


    Return to the WLAN view.

  6. Bind the radio profile to an AP group or a specific AP. For the detailed procedure, see Binding a Radio Profile.
  7. Run:


    Return to the WLAN view.

  8. Run:

    commit { all | ap-name ap-name | ap-id { ap-id1 [ to ap-id2 ] } &<1-10> }

    Configurations are delivered to APs.

Verifying the Configuration

  • Run the display radio-2g-profile name profile-name command to check the smart antenna configuration of an AP in a 2G radio profile.
  • Run the display radio-5g-profile name profile-name command to check the smart antenna configuration of an AP in a 5G radio profile.
Updated: 2019-12-28

Document ID: EDOC1000141952

Views: 203435

Downloads: 522

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next