No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S5720HI V200R010C00 Configuration Guide - WLAN-AC

This document describes native AC (hereinafter referred to as WLAN AC) configuration procedures and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Online Parameters

Configuring Online Parameters


By default, no online parameters are configured on APs in the AP view. If AP online parameters are configured in the AP view, run the display ap provision command to display the configurations.


  1. Run:


    The system view is displayed.

  2. Run:


    The WLAN view is displayed.

  3. Run:

    ap-id ap-id, ap-mac ap-mac, or ap-name ap-name

    The AP view is displayed.

  4. Run:

    ap-name ap-new-name

    A name is configured for an AP.

    By default, no AP name is configured for an AP.


    The new AP name cannot be the same as the existing AP name.

  5. Run:

    ap-group ap-group

    The AP group to which an AP belongs is modified.

    By default, no AP group is configured.

  6. Run:

    address-mode { dhcp | static }

    The method used by an AP to obtain an IPv4 address is configured.

    By default, the mode in which an AP obtains an IP address is not configured.

  7. (Optional) Run:

    ip-address ip-address { mask-length | mask } [ gateway gateway ]

    A static IPv4 address and gateway for an AP are configured.

    By default, no static IPv4 address and gateway are configured for an AP.


    This step is performed only if APs obtain IP addresses in static mode.

  8. Run:

    ac-list ipv4-address &<1-4>

    An AC IPv4 address list for an AP is configured.

    By default, no AC IPv4 address list is configured.

Verifying the Configuration

  • Run the display ap provision ap-id ap-id command to display the parameter configurations in the AP view.
Updated: 2019-12-28

Document ID: EDOC1000141952

Views: 201774

Downloads: 522

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next