No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S5720HI V200R010C00 Configuration Guide - WLAN-AC

This document describes native AC (hereinafter referred to as WLAN AC) configuration procedures and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Online Parameters

Configuring Online Parameters


By default, no online parameter is configured in the AP provisioning view, namely, APs do not change default online parameter configurations. You can run the display provision-ap parameter-list command to view online parameter configurations in the AP provisioning view.
  • After configurations are delivered to APs using the commit { ap-name ap-name | ap-mac ap-mac-address | ap-id ap-id | ap-group ap-group-name | all } command, the parameters displayed as - in the command output retain the default settings,

  • and the other parameters use the configured values.


  1. Run:


    The system view is displayed.

  2. Run:


    The WLAN view is displayed.

  3. Run:


    The AP provisioning view is displayed.

  4. Run:

    ap-name ap-new-name

    A name is configured for an AP.

    By default, no AP name is configured.


    The new AP name cannot be the same as the existing AP name.

  5. Run:

    ap-group ap-group

    The AP group to which an AP belongs is modified.

    By default, no AP group is configured.

  6. Run the address-mode { dhcp | static } command to configure the method used by an AP to obtain an IPv4 address.

    By default, the mode in which an AP obtains an IP address is not configured.

  7. (Optional) Run the ip-address ip-address { mask-length | mask } [ gateway gateway ] command to configure a static IPv4 address and gateway for an AP.

    By default, no static IPv4 address and gateway are configured for an AP.


    This step is performed only if APs obtain IP addresses in static mode.

  8. Run the ac-list ipv4-address &<1-4> command to configure an AC IPv4 address list for an AP.

    By default, no AC IPv4 address list is configured.

Verifying the Configuration

  • Run the display provision-ap parameter-list command to check parameter configurations in the AP provisioning view.
Updated: 2019-12-28

Document ID: EDOC1000141952

Views: 201073

Downloads: 522

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next