No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

S9300, S9300E, and S9300X V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
SW_SNPG_1.3.6.1.4.1.2011.5.25.44.99.34 hwL2mcCacLdpPwChannelCountExceed

SW_SNPG_1.3.6.1.4.1.2011.5.25.44.99.34 hwL2mcCacLdpPwChannelCountExceed

Description

SW_SNPG/4/LDPPWCNTEXCEED:OID [OID] Exceed the count limit on multicast groups. (PwId=[INTEGER], RemoteIpAddress=[IPADDR], ConfiguredValue=[INTEGER], CurrentMulticastGroup=[IPADDR])

Layer 2 multicast CAC detected that the number of multicast groups in a channel on a PW-side interface exceeded the configured limit.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.44.99.34 Warning equipmentAlarm(5)

Parameters

Name Meaning

OID

Indicates the MIB object ID of the alarm.

PwId

Indicates the PW ID.

RemoteIpAddress

Indicates the remote IP address of the PW.

ConfiguredValue

Indicates the configured limit on the number of multicast groups.

CurrentMulticastGroup

Indicates the multicast group address.

Impact on the System

Multicast data cannot be forwarded to new multicast groups and users cannot join new multicast groups, but this is a result of normal configuration.

Possible Causes

Users connected to the PW-side interface attempted to join new multicast groups in the channel after the number of multicast groups in the channel on the PW-side interface reached or exceeded the configured limit.

Procedure

  1. Run the display l2-multicast limit configuration vsi vsi-name remote-peer ip-address [ negotiation-vc-id vc-id ] command to check whether the limit on the number of multicast groups configured for the channel on the PW-side interface is too small.

    • If so, go to step 2.

    • If not, go to step 3.

  2. Increase the limit on the number of the multicast groups in the channel on the PW-side interface based on application requirements, and then check whether the alarm persists.

    • If so, go to step 3.

    • If not, no further action is required.

  3. Collect alarm, log, and configuration information, and contact technical support personnel.
Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142054

Views: 192609

Downloads: 44

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next