No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

S9300, S9300E, and S9300X V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
PIM-STD_1.3.6.1.2.1.157.0.1 PimNeighborLoss

PIM-STD_1.3.6.1.2.1.157.0.1 PimNeighborLoss

Description

PIM-STD/2/PUBLIC_NBRLOSS:OID [oid] PIM neighbor loss. (NbrIntIndex=[integer], NbrAddrType=[integer], NbrAddr=[binary], NbrUpTime=[timetick])

A PIM neighbor relationship was lost.

Attribute

Alarm ID Alarm Severity Alarm Type

1.3.6.1.2.1.157.0.1

Major

communicationsAlarm(2)

Parameters

Name Meaning

oid

Indicates the MIB object ID of the alarm.

NbrIntIndex

Index of a neighbor

NbrAddrType

Indicates the inetAddressType of neighbor address. The value can be:
  • 1: IPv4 address

  • 2: IPv6 address

NbrAddr

Address of a neighbor

NbrUpTime

Time elapsed since a neighbor relationship was established

Impact on the System

The PIM neighbor relationship will be interrupted and multicast services will be affected.

Possible Causes

Cause 1:

The timer of a PIM neighbor expired.

Cause 2:

The switch received a Hello packet with the Holdtime field of 0.

Procedure

  1. Run the display pim interface interface-type interface-number command on a PIM neighbor. Check whether PIM is enabled on the interface connecting the PIM neighbor to the local switch.

    • If PIM is enabled on the interface, go to step 3.

    • If PIM is disabled on the interface, go to step 2.

  2. Run the pim dm or pim sm command to enable PIM on the interface connecting the PIM neighbor to the local switch. Run the display pim neighbor neighbor-address command on the PIM neighbor to view the PIM neighbor relationship status.

    • If the PIM neighbor relationship is established, go to step 6.

    • If the PIM neighbor relationship is not established, go to step 3.

  3. Run the display ip routing-table ip-address command on the PIM neighbor to view the route to the local switch.

    • If the route is reachable, go to step 5.

    • If the route is unreachable, go to step 4.

  4. Rectify the route fault to clear the trap. After the route becomes reachable, run the display pim neighbor neighbor-address command on the PIM neighbor to view the PIM neighbor relationship status.

    • If the PIM neighbor relationship is established, go to step 6.

    • If the PIM neighbor relationship is not established, go to step 5.

  5. Collect alarm information and configuration information, and then contact technical support personnel.
  6. End.

Related Information

None

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142054

Views: 182139

Downloads: 44

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next