No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Alarm Handling

S9300, S9300E, and S9300X V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
PIM_1. hwPimSGThresholdExceed

PIM_1. hwPimSGThresholdExceed


PIM/3/hwPimSGThresholdExceed:OID [oid] PIM (S, G) entries of all instances count reached the upper threshold. (hwPimNotificationAddressType=[integer], hwPimSGCurrentCount=[integer], hwPimSGThreshold=[integer]%, hwPimSGTotalCount=[integer])

The proportion of global PIM (S, G) entries created to the maximum global PIM (S, G) entries allowed reached the upper alarm threshold.


Alarm ID Alarm Severity Alarm Type




Name Meaning


Indicates the MIB object ID of the alarm.


Group address type:
  • 1: IPv4 address

  • 2: IPv6 address


Number of global PIM (S, G) entries created


Alarm threshold for global PIM (S, G) entries


Maximum number of global PIM (S, G) entries allowed

Impact on the System

If the number of (S, G) PIM entries in the system reaches the upper limit and this alarm is reported, the device cannot create new PIM entries, causing failures to forward some multicast traffic.

Possible Causes

The proportion of global PIM (S, G) entries created to the maximum global PIM (S, G) entries allowed reached the upper alarm threshold.


  1. Check whether the upper alarm threshold is too low in the configuration file.

    • If the threshold is too low, go to Step 2.

    • If the threshold is not low, go to Step 3.

  2. Run the pim source-group-number threshold-alarm upper-limit upper-limit-value lower-limit lower-limit-value command in the multicast MIB view to set the upper alarm threshold to a larger value.
  3. Confirm whether network expansion is required. If network expansion is required, contact technical support personnel.
  4. End.

Related Information


Updated: 2019-08-21

Document ID: EDOC1000142054

Views: 189762

Downloads: 44

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next