No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

S9300, S9300E, and S9300X V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ENTITYTRAP_1.3.6.1.4.1.2011.5.25.219.2.3.5 hwCardInvalid 135463

ENTITYTRAP_1.3.6.1.4.1.2011.5.25.219.2.3.5 hwCardInvalid 135463

Description

ENTITYTRAP/1/CARDINVALID:OID [oid] Card is invalid for some reason. (Index=[INTEGER], EntityPhysicalIndex=[INTEGER], PhysicalName="[OCTET]", EntityTrapEntType=[INTEGER], EntityTrapFaultID=[INTEGER], EntityTrapReasonDescr="[OCTET]")

The subcard does not work.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.219.2.3.5 Critical environmentalAlarm(6)

Parameters

Name Meaning
oid Indicates the ID of a MIB object.
Index Indicates an alarm ID.
EntityPhysicalIndex Indicates the index of the physical entity where the alarm is reported.
PhysicalName Indicates the physical entity name.
EntityTrapEntType Indicates the alarm type.
EntityTrapFaultID Indicates the error code of the alarm.
EntityTrapReasonDescr Indicates the description of the alarm cause.

Impact on the System

Services cannot run normally on the switch.

Possible Causes

Cause 1: The CSS subcard installed in the MPU does not match the MPU.

Cause 2: The subcard does not support hot swap but it has been hot swapped.

Procedure

  • Cause 1: The CSS subcard installed in the MPU does not match the MPU.

    Replace the CSS subcard with one that matches the MPU.

  • Cause 2: The subcard does not support hot swap but it has been hot swapped.

    Restart the switch after installing or removing the subcard. Restarting the switch will interrupt running services. It is recommended that you restart the switch during off-peak hours.

Related Information

None

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142054

Views: 182378

Downloads: 44

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next