No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

S9300, S9300E, and S9300X V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ENTITYTRAP_1.3.6.1.4.1.2011.5.25.219.2.2.8 hwBoardBecomeMaster 133120

ENTITYTRAP_1.3.6.1.4.1.2011.5.25.219.2.2.8 hwBoardBecomeMaster 133120

Description

ENTITYTRAP/4/BOARDBECOMEMASTER: OID [oid] MPU become master role. (Index=[INTEGER], EntityPhysicalIndex=[INTEGER], PhysicalName="[OCTET]", EntityTrapEntType=[INTEGER], EntityTrapFaultID=[INTEGER])

The standby MPU becomes the active MPU.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.219.2.2.8 Warning equipmentAlarm(5)

Parameters

Name Meaning
OID Indicates the ID of the MIB object.
Index Indicates the index.
EntityPhysicalIndex Indicates the physical index.
PhysicalName Indicates the name of the physical entity.
EntityTrapEntType Indicates the alarm type of the physical entity.
EntityTrapFaultID Indicates the error code.

Impact on the System

None.

Possible Causes

Cause 1: The active MPU was reset.

Cause 2: The active MPU was reinstalled when the device is running.

Cause 3: The slave switchover command was run.

Cause 4: The active MPU was faulty.

Procedure

  1. Check whether the original active MPU was reset using the reset slot command or its power is turned off.

    • If so, the alarm handling ends.
    • If not, go to step 2.

  2. Check whether the slave switchover command was executed.

    • If so, the alarm handling ends.
    • If not, go to step 3.

  3. Run the display device command to check whether the original active MPU is installed properly.

    • If so, go to step 5.
    • If not, go to step 4.

  4. Install the original active MPU securely, and then run the display device command to check whether the original active MPU is available.
  5. Check whether the original active MPU is faulty. Perform the active/standby switchover again to check whether the switchover succeeds.

    • If so, the alarm handling ends.
    • If not, collect alarm information and configuration information, and then contact technical support personnel.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142054

Views: 190877

Downloads: 44

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next