No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

S9300, S9300E, and S9300X V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
CSSM_1.3.6.1.4.1.2011.5.25.183.3.3.2.16 hwCssStandbyError

CSSM_1.3.6.1.4.1.2011.5.25.183.3.3.2.16 hwCssStandbyError

Description

CSSM/2/CSSNOMPU: OID [OID] The CSS enters the standby-no-MPU state.

The CSS enters the standby-no-MPU state.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.183.3.3.2.16 Major equipmentAlarm(5)

Parameters

Name Meaning
OID Indicates the ID of the alarm MIB object.

Impact on the System

You can only run the display commands but cannot use the configuration commands.

Possible Causes

  • The last MPU in the master or standby chassis is removed.

  • The last MPU in the master or standby chassis is reset.

  • The last MPU in the master or standby chassis fails.

Procedure

  1. Run the display device command to check whether there is any MPU present in the standby chassis.

    • If no MPU is present in the standby chassis, install an MPU in the standby chassis and wait until the MPU registers successfully.
    • If an MPU is present in the standby chassis but does not register in a long time, this MPU has failed. Replace the MPU and wait until the new MPU registers successfully.

  2. Run the display css status command to check whether the CSS is working in normal state.

    • If so, no action is required.
    • If not, collect alarm information and configuration information, and then contact technical support personnel.

Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142054

Views: 183494

Downloads: 44

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next