No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

S9300, S9300E, and S9300X V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
USBLOAD_1.3.6.1.4.1.2011.5.25.129.2.1.10 hwEntityResume

USBLOAD_1.3.6.1.4.1.2011.5.25.129.2.1.10 hwEntityResume

Description

USBLOAD/4/UsbPlugOut: OID [oid] u-disk plug out. (EntityPhysicalIndex=[INTEGER], BaseTrapSeverity=[INTEGER], BaseTrapProbableCause=[INTEGER], BaseTrapEventType=[INTEGER], EntPhysicalContainedIn=[INTEGER], EntPhysicalName=[OCTET], RelativeResource=[OCTET], ReasonDescription=[OCTET])

The USB flash drive was removed from the device.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.129.2.1.10 Warning equipmentAlarm(5)

Parameters

Name Meaning
OID Indicates the OID of the MIB.
EntityPhysicalIndex Indicates the index of the physical entity.
BaseTrapSeverity Indicates the severity code.
BaseTrapProbableCause Indicates the error code.
BaseTrapEventType Indicates the code of the event type.
EntPhysicalContainedIn Indicates the code of the physical entity.
EntPhysicalName Indicates the name of the physical entity.
RelativeResource Indicates the name of the affected component.
ReasonDescription Indicates the fault description.

Impact on the System

If the USB-based deployment is complete, the normal USB-based deployment process ends. If the USB-based deployment is being performed, the deployment fails.

Possible Causes

The USB flash drive was removed from the device.

Procedure

  1. This alarm is informational only, and no action is required. To start the USB-based deployment process again, insert the USB flash drive into the device.
Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000142054

Views: 190841

Downloads: 44

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next